Kasama Raptor 30/50 Rotor Head
£139.95
- Product Code 00002
FEATURES
Main rotor hub - 64 grams
- Machined from 7075 T6 aluminum
- Hub mounts using a pin and clamp design.
- Clamp design eliminates hub rocking on the shaft yielding crisp, 3D performance.
- Hub comes with four bearings pre-installed
Flybar control arm - 18 grams
- Machined from 7 series aluminum
- The control arm is a single sided design allowing for easier disassembly and adjustment.
Washout set - 16 grams
- Mixing arms are machined from 5 series aluminum
- Washout arms are equipped with set screws to secure the washout linkage pivot pins. (washout links and pivot pins are not included)
- Flange bearings are included and pre-installed.
- Washout arms are machined with an additional control hole yielding increased control and response.
Washout base - Machined from 7 series aluminum.
- Washout base is taller than stock, the result is a wider bearing surface offering smoother, low friction movement.
Mixing levers - 12 grams
- Machined from 7 series aluminum
- Flange bearings are included and pre-installed yielding a slop free pivot point.
- Mixing lever length is increased with an additional control hole allowing for more aggressive control.
Blade grips - 60 grams- grips, levers and hardware
- Machined from 7075 T6 aircraft aluminum
- Grips are designed to be used with stock raptor bearings (not included)
- Blade grip control arms are offset 3 degrees lower than stock. This allows for more leverage at extreme negative blade pitch angles.